silikontraveler.blogg.se - Set extruder location repetier server

SET EXTRUDER LOCATION REPETIER SERVER DRIVERS
SET EXTRUDER LOCATION REPETIER SERVER CODE
SET EXTRUDER LOCATION REPETIER SERVER PC

Go to General - Advanced - place a check mark next to "Use firmware retraction".In order to avoid stringing it is important to let the firmware do the retraction. In Config -> Preferences setup a slightly better lighting scheme by clicking 3D Visualization, then clicking Lights, enabling all the checkboxes and entering these numbers:.Mixing the secondary colors produces the various colors including the primary colors red, green and blue, however because of imprecise cyan and magenta colors used here, the mixing outcome was not very accurate. In the text field below copy and paste the following script in order to setup a rainbow on virtual extruders 0 till 11 and grey-brownish colors on virtual extruders 12-15Įxample printout of the color palette shown below with the secondary colors Cyan, Magenta and Yellow in positions 1, 5 & 9 as seen from the left.

SET EXTRUDER LOCATION REPETIER SERVER CODE

Click the drop down menu Scripts and select Script 1 (alternatively select Start Code in order to use this color scheme every time you slice).To enter a color representation in Repetier-Host of the mixed filament, for each of the extrudes below enter a name, then click the color rectangle, click Define Custom Colors > and enter the following Red, Green and Blue values:.Set a checkmark in the box Printer has a Mixing Extruder (one nozzle for all colors).In Config -> Printer Settings select the Extruder pane.Mixing extruder (one nozzle for all colors).3D-printer setup with Repetier-firmware v0.92 (or later) as specified above.

SET EXTRUDER LOCATION REPETIER SERVER PC

A PC running Repetier-Host V1.6 or later (some earlier versions may work but these are not tested).

If you have a board not mentioned here, please refer to the documentation of that board in order to obtain the necessary pin assignments. (pin numbers shown are the digital pins corresponding to a Ramps board with a Stepper Expander X1 connected as described on Adding more extruders) #define E2_PINS ORIG_E2_STEP_PIN,ORIG_E2_DIR_PIN,ORIG_E2_ENABLE_PIN, In Pins.h (scroll down into the “RAMPS pin assignment” section or the board matching your setup) make sure the following lines are present, if not add them: RUMBA boards already feature 6 stepper motor outputs so the below changes does not apply to that board.

SET EXTRUDER LOCATION REPETIER SERVER DRIVERS

Since Ramps has only two on-board extruders drivers you physically need to attach a third extruder driver externally eg. Download the complete firmware at the end of the configurator.

Optional: make appropriate changes to fit your specific printer.

Then upload it to the configurator mentioned above.

Go to File:DiamondRepetierConfiguration.h and save the file as configuration.h.

In order to create a working setup it is possible to download a fresh copy of Repetier-Firmware from the v092 configurator